Radio antennas in the form of a shark fin to replace the standard ones. After replacing the antenna, the overall appearance of the car roof takes on a more modern and neat look. Also, after installing such an antenna, the problem in automatic car washes, whose brushes could damage the old ones in the form of a spoke, will be eliminated.

Installed with double-sided tape or sealant.

The antenna is not only decorative, but also a full replacement for the standard one. Inside the case there is a board with an active electronic antenna to avoid signal deterioration after removing the standard one in the form of a spoke.

The antenna has a soft rubber seal at the point of contact with the body. Installed with double-sided 3M tape included in the kit. Length 160 mm, width 78 mm, height 70 mm.

Variant 2. The antenna is attached to the double-sided tape included in the kit. Length 170 mm, width 70 mm, height 65 mm.

< /p>

< /p>

< /p>

< /p>

< /p>

< /p>

< /p>