Repair board 7162209 with modern LEDs (light-emitting diodes) and driver for complete restoration of the left outer rear lamp (brake light and tail light) of BMW X3 E83 vehicles. This is an effective repair solution, not a full lamp replacement, allowing for significant savings.
Note: We sell the repair kit. We do not perform the board replacement on your lamp. Installation is carried out by the buyer independently or at a service center.
The kit fully restores bright and even illumination, eliminating typical E83 problems: dimmed segments, flickering, or complete LED failure. The repaired lamp will function like new, without errors in the vehicle's onboard system (no exterior light warning lamp).
What's included in the repair kit:
- Board with high-quality LEDs assembled on modern components.
- Integrated driver (power controller) for stable operation.
- All necessary electronic components for mounting.
Advantages of purchasing repair board 7162209:
- Savings: Repair cost is significantly lower than buying a new original lamp.
- Quality: Reliable LEDs with a long service life are used.
- Compatibility: Perfectly fits BMW X3 E83 (left outer side).
- Easy Installation: For someone with soldering skills, the replacement process is not complicated. It's enough to carefully open the lamp housing, remove the old board, and solder the new one in place.
Watch the video clearly demonstrating the repair process and the board's operation after installation:
For clarity, detailed photos of the 7162209 repair board are provided below. You can assess the soldering quality, installed LEDs, and components.




Compatibility and Key Information Table:
| Parameter | Value / Description |
|---|
| Product Code (Article) | 7162209 |
| Car Model | BMW X3 E83 |
| Location | Rear left outer lamp (left brake light and tail light) |
| Repair Kit Type | Board with LEDs and driver |
| Condition | New |
| Primary Purpose | Restoration of dimmed, flickering, or non-functioning rear lamp segments |
| Installation Difficulty | Medium (requires careful lamp housing disassembly and soldering skills) |
Frequently Asked Questions:
Will this board fit the right side? No, for the right outer lamp you need the repair kit with article number 7162210. For the inner lamps (trunk side), boards 7162213 (left) and 7162214 (right) are used.
What is needed for installation? You will need a soldering iron, solder, flux, and tools for carefully opening the lamp housing (heat gun, thin screwdrivers).
Will the lamp's seal remain intact after repair? Yes, if you carefully separate and then properly glue the housing halves back together with a special headlight sealant.
By choosing the repair board 7162209, you are opting for a sensible and economical way to restore your BMW X3 E83's flawless appearance and road safety. All components are tested, the board is ready for installation.